TS | Self-clinching Sheet-Loc™ Fastener

All Products / Self-clinching Hardware / Inch Self-clinching Standoffs / TS | Self-clinching Sheet-Loc™ Fastener


Request a quote or more information on this product by clicking the button below. A member of our sales staff will contact you promptly.

Product Description: N/A Category: Tag:

Features
  • Join two sheets together by simply sliding the top panel into place for a quick attachment and detachment of removable components.
  • Use several TJ Sheet-Loc™ Fasteners with one PENCOM NG Flush Nut to prevent unwanted top sheet movement, and reduce installation time and excess hardware.
  • Can be installed in a blind hole to conceal fastener head.


When second sourcing PENCOM’s products, PENCOM recommends that the part is tested in the application to ensure that it will meet all performance requirements.

Application

Panel 1Panel 2
Mounting Hole B
+.003
-.000
Sheet Hardness Max.Sheet Thickness Min.Edge Distance C1 Min.Mounting hole AMaterialThicknessEdge Distance C2 Min.
A1 nom.A2
±.003
A3
±.003
A4
Min.
.213HRB 70.039 (1).150.059.118.197.148Metal or
P.C. Board
. 057 Ð .064.160

Installation

Thru-hole Installation
  • For a thru-hole application punch or drill hole in sheet. Do not deburr edges.
  • Insert fastener into the anvil and locate sheet hole over the fastener shank as shown.
  • Squeeze the sheet and fastener flange between parallel punch and anvil surfaces. Use only enough pressure to seat the flange flush with the sheet. Punch and anvil may be ordered using PENCOM part numbers TL1287 and TL1363, respectively, or made from hardened tool steel.
Blind Hole Installation
  • For a blind hole application mill a properly sized blind hole .043” (1.10mm) deep minimum in sheet. Do not deburr edges.
  • Insert fastener into the anvil and locate sheet hole over the fastener shank as shown.
  • Squeeze the sheet and fastener flange between parallel punch and anvil surfaces. Use only enough pressure to seat the flange flush with the sheet. Punch and anvil may be ordered using PENCOM part numbers TL1287 and TL1363, respectively, or made from hardened tool steel.

Performance

Test Sheet Material
.060″ 5052-H34 Aluminum.060″ Cold-Rolled Steel
Installation
(lbs)
Push-out
(lbs)
Side Load Max. (lbs)Installation
(lbs)
Push-out
(lbs)
Side Load Max. (lbs)
11001201202100160185

Material & Finish

Material CodeMaterial DescriptionFinish CodeFinish Description
SSStainless SteelP Passivated

Contact a PENCOM Account Representative for other material & finish options.