BS13 | Swage-in Ball Studs

All Products / Ball Studs and Clips / Metric Ball Studs and Clips / BS13 | Swage-in Ball Studs


Clear
Product Description: N/A Category: Tag:

Dimensions

General
Sheet 1
Thickness
Length
Code
L
±.010
S
±.005
Anvil
A
0.64-1.30 421 10.69 8.33 7.95
1.31-1.98 447 11.35 8.99 8.61
1.99-2.67 473 12.01 9.65 9.27
2.68-3.35 499 12.67 10.31 9.93
3.36-4.04 525 13.34 10.97 10.59
4.05-4.75 551 14.00 11.63 11.25
.177-.203 570 .570 .477 .462
.230-.256 625 .625 .532 .517
Length
Sheet 2 Thickness Shank
Length
Code
T
±.003
Sheet
B
Swage-In Flare-In
Min.
.031 .095 A .075 .015
.062 .125 B .105 .035
.094 .155 C .135 .065
.125 .185 D .165 .095
.187 .250 E .230 .160
.250 .310 F .290 .220

Installation

Swage-In Installation
  1. Prepare the sheet as shown for swage–in installation.
  2. Insert the ball stud into recessed anvil and place sheet hole over ball stud shank.
  3. Squeeze the ball stud between parallel and concentric anvil and punch. Swage the ball stud shank using light pressure. Anvil should be made from hardened steel. Punch may be ordered using PENCOM part number TL1197.

Flare-In Installation
  1. Prepare the sheet as shown for flare–in installation.
  2. Insert the ball stud into recessed anvil and place sheet hole over ball stud shank.
  3. Squeeze the ball stud between parallel and concentric anvil and punch. Flare the ball stud shank into the sheet countersink using light pressure. Punch flare angle should match the sheet hole countersink angle. Anvil and punch should be made from hardened steel.

Material & Finish

Material CodeMaterial DescriptionFinish CodeFinish Description
SSStainless SteelP Passivated

Contact a PENCOM Account Representative for other material & finish options.